Dencoat - Tomorrow's Floors Today

Systems

Denspartic Standard

(3-4 mm)

Polyaspartic based flooring system.
Recommended for areas, which are subject to moderate mechanical or chemical wear with high hygienic demands, such as food industry, wash rooms, and other areas, where an anti-slip surface and easily cleanable floor is required.

Benefits

Aesthetically Pleasing, Silkmat Surface
Very Good Chemical Resistance
Weatherproof & UV Resistant
Fast Installation
Low Maintenance Cost
Non Slip Finish if required
Easy to Clean & Sterilize

Applications

For all types of medium load industrial floors, in combination with high demands to hygiene and cleanability. Denspartic Standard is flexible with excellent wearability, impact and chemical resistance. Denspartic Standard is easy to clean and maintain in a hygienic condition. The very fast curing of Denspartic means, that eventual production stop is minimized while installing the floor.

Scope of use

Wet areas with anti-slip requirements
Wash & bath rooms
Food & Beverage

Application conditions

Temperature 5ºC to 30ºC, best 15 to 25ºC, max. moisture content in the concrete subfloor 5% by weight.

Appearance

Denspartic Standard is a non-slip multicoloured floor with a silkmatt finish.

Temperature Resistance

Denspartic Standard is resistant to temperature cycles up to 80°C. Extended periods at these temperatures and above will make material susceptible to chemical attack and abrasion wear.

Life Expectancy

10 - 15 years.

Colours

See separate color chart.

System Build-up

LAYER	PRODUCT	CONSUMPTION (kg/m²)	INTERMEDIATE	THICKNESS (mm)	APPLICATION
Primer	Denspartic AP	0.3 - 0.5	Scatter quartz 0.7 - 1.2 on wet surface	Min 0.3	Rubber squeegee and paint roller
Wear Layer	Denspartic ACB + Color Quartz	1.5 + 4.0	Full broadcast of Color Quartz on wet surface	3.0 - 4.0	Notched rubber squegee and trowel
Top coat	Denspartic AS	0,7 - 1.2	None	0.7 - 1.2	Rubber squegee and paint roller

Technical Data

Properties

Value

Abrasion resistance

50 mg / 1000 cycles (Taber Abrader)

Anti-slip according to DIN 51130

R9 – R13

Applied thickness

2 - 4 mm

Bond strength

>1.5 MPa

Compressive strength

60 MPa

Food Contact

No contamination

Fully cured at 20°C

2 hours

Hardness

SHORE D 40

Reaction to fire

Bfl-s1

Temperature resistance

Up to 80°C

Thermal conductivity

< 0,4 W/m·K

Thermal expansion coefficient

<40 ppm

Water Permeability

Nil – Karsten test (impermeable)

Colours